Without the professionally developed thermal protection of the building socle, the thermal insulation effectiveness for the upward walls, floors on the soil, and basement sidewalls decreases significantly.
The application of the moisture and frost resistant, high strength RAVATHERM™ XPS 300 WB closed-cell polystyrene foam thermal insulation provides a lasting and efficient solution, even as a supplement to ventilated façade systems prepared using other thermal insulation materials.
RAVATHERM XPS 300 WB socle thermal insulation must be lead up to a height of at least 30 cm above the level of the surrounding terrain due to capillary action and splashing moisture
The thermal insulation of the building socle is subjected to intense stresses: soil moisture, precipitation, splashing water, mechanical impacts, humic acids, etc., therefore long-lasting reliable operation can only be ensured by choosing the heat insulating material that meets the requirements. The application of the RAVATHERM XPS 300 WB extruded polystyrene thermal insulation foam provides a lasting and efficient solution, as a result of the beneficial material characteristics:
- closed-cell structure – negligible moisture uptake, frost resistance
- high strength, flexible rigidity – resistance to mechanical impacts
- rough surface – high strength adherence to concrete, mortars and solvent-free adhesives
INSTALLATION OF RAVATHERM XPS ON BUILDING SOCLES
Where the RAVATHERM XPS thermal insulation is to be connected to brick walls or to other thermal insulation materials, or where it is connected to the thermal insulation material of the basement perimeter wall, efforts have to be made to achieve close, accurate matching.
Socle thermal insulation can be used as permanent insulated formwork or installed subsequently.
When a plastic bituminous adhesive is used, supporting or additional mechanical fastening of the thermal insulation boards is also necessary.
The appropriate surface resistance of thermally insulated building socles can be ensured by a strengthened plaster layer, glued cladding or double walling or reinforced concrete, artificial stone or carved stone tiling.
BRICK, STONE AND TILE CLADDING
In the case of glued stone or ceramic tiling, a fibreglass mesh reinforcement is to be applied to the thermal insulation glued on the entire surface, embedded into the adhesive. Up to 25 kg/m2 cladding weight a single layer, from 25 to 40 kg/m2 cladding weight double layer of fibreglass mesh is to be used. Stone and artificial stone claddings are to be installed according the related technological rules for tiling work. Erecting double walls is to be made according to the rules for walling structures (taking care of the foundation of the double wall!)
The embedded single-layer fiberglass reinforcement is fixed by disc dowels and dowel nails, calculated with max. 8 kg cladding load on one dowel. In the case of double-layer fiberglass mesh, dowels are driven between the two mesh layers, calculated with the same weight distributions. Cladding tiles can be glued onto the crust so formed, using the appropriate adhesive and jointing.